SANRAD V-Switch manual Safety Notices

Safety Notices

Read and understand the following notices before installing the V-Switch.

The power plug must be accessible at all times because it serves as the main disconnecting vehicle.

Unplug the V-Switch power cord before performing maintenance procedures.

The V-Switch contains two power supply units. To disconnect the V-Switch completely, all power supply cords must be unplugged.

Do not touch the power supplies when their power cords are connected. Line voltages are present within the power supplies when their cords are connected.

The safety cover is an integral part of this product. Do not operate the unit without the safety cover firmly in place. Operating the unit without the cover in place will invalidate the safety approvals and pose a risk of fire and electrical hazards.

Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI) shields that might disrupt other equipment; and they direct flow of cooling air through the chassis. Do not operate the system unless all cards and faceplates are in place.

This product relies on the building’s wiring for short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15a U.S. (240 VAC, 10A international) is used on the phase conductors (all current-carrying conductors).

The V-Switch is intended to be grounded. Ensure that the V-Switch is connected to earth ground during normal use.

When installing the V-Switch, the ground connection must always be connected first and disconnected last.

There is a danger of explosion if the motherboard battery is replaced incorrectly. Replace the battery with the same or an equivalent type as recommended by the manufacturer. Dispose of the used battery according to the manufacturer’s instructions.

SANRAD V-Switch User Manual