Zebra Technologies 14245L-003 manual Externalwired.ip.addr, 217, U1 setvar externalwired.ip.addr

SGD Wired Commands

external_wired.ip.addr

217

external_wired.ip.addr

Description This command allows you to get or set the external wired print servers’s IP address. For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Important • For a set IP address to take affect, the IP protocol must be set to permanent and the print server must be reset.

Note • For details on SGD command structure, see Command Structure on page 216.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with its current external
	wired print server IP address.
	Format: ! U1 getvar "external_wired.ip.addr"
setvar	This command instructs the printer to change its current external wired
	print server IP address upon powering the printer on.
	Format: ! U1 setvar "external_wired.ip.addr" "value"
	Values: any valid IP address
	Default: "0.0.0.0"

Note • The setvar value of this command can be affected by the external_wired.ip.dhcp.enable command.

Example • This setvar example shows the value set to "10.14.4.235".

! U1 setvar "external_wired.ip.addr" "10.14.4.235"

What the setvar value is set to is the getvar result. In this example, the getvar result is "10.14.4.235".

12/16/13 EPL Programming Guide 14245L-003 Rev. A