Zebra Technologies 14245L-003 manual Ip.gateway, 262, U1 setvar ip.gateway

262

ip.gateway

ip.gateway

Description This command instructs the printer to change the gateway address. For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Important • This setting refers to the gateway address. A set value is ignored if the IP protocol is not set to permanent.

Note • For details on SGD command structure, see Command Structure on page 250.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with the gateway address.
	Format: ! U1 getvar "ip.gateway"
setvar	This command instructs the printer to change the gateway address.
	Format: ! U1 setvar "ip.gateway" "value"
	Values: Any valid gateway address
	Default: "0.0.0.0"

Example • This setvar example shows the value set to "10.3.5.1".

! U1 setvar "ip.gateway" "10.3.5.1"

When the setvar value is set to "10.3.5.1", the getvar result is "10.3.5.1".

14245L-003 Rev. A EPL Programming Guide 12/16/13