Zebra Technologies 14245L-003 manual Internalwired.ip.protocol, 243

SGD Wired Commands

internal_wired.ip.protocol

243

internal_wired.ip.protocol

Description This command configures the IP addressing method used by the internal wired print server. For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Note • For details on SGD command structure, see Command Structure on page 216.

This table identifies the command for this format:

Commands	Details
getvar	This command returns the IP addressing method used by the internal wired
	print server.
	Format: ! U1 getvar "internal_wired.ip.protocol"
setvar	This command instructs the printer to configure the IP addressing method
	used by the internal wired print server.
	Format:
	! U1 setvar "internal_wired.ip.protocol" "value"
	Values:
	"bootp" = uses the standard bootp addressing method to obtain an
	IP address and configuration
	"dhcp" = uses the standard dhcp addressing method to obtain an IP
	address and configuration for a server specified period of time
	"rarp" = uses the standard rarp addressing method to obtain an IP
	address
	"glean" = uses the IP address from a PING packet that is sent to its
	hardware address (unicast address)
	“permanent” = uses static values assigned through other
	commands
	"all" = tries all of the dynamic addressing methods, not permanent,
	to obtain an IP address
	Default: "all"

Example • In this example, the setvar result is the current programming language that the printer is using.

! U1 setvar "internal_wired.ip.protocol" "bootp"

What the setvar value is set to is the getvar result. In this example, the getvar result is "bootp".

12/16/13 EPL Programming Guide 14245L-003 Rev. A