124

EPL Commands

oB

oB

Cancel Auto Bar Code Optimization

Description This command allows the advanced programmer to disable bar code optimization for rotated (90° & 270°) bar codes.

Syntax oB

Parameters Thre are no parameters for this format.

The oB command is a global printer command.

It can not be issued inside of a form.

It must be issued prior to issuing a bar code command (and printing).

To reapply bar code defaults, issue an o (small letter “o”) command. See page C-90 for important details on the effects of using the o command.

Reset the printer with a ^@ command with flash firmware printers or cycle printer power to clear the oB command and return the printer to normal operation.

Important • Zebra Technologies Corporation does not warrant, support, or endorse the use of bar codes generated by the printer after a oB command has been issued.

Zebra Technologies Corporation does not support this feature other than with the information supplied in this document.

14245L-003 Rev. A

EPL Programming Guide

12/16/13

Page 124
Image 124
Zebra Technologies 14245L-003 manual Cancel Auto Bar Code Optimization, 124, Syntax oB