Zebra Technologies 14245L-003 manual Wlan.ip.dhcp.cidtype, 278, U1 setvar wlan.ip.dhcp.cidtype

278

SGD Wireless Commands

wlan.ip.dhcp.cid_type

wlan.ip.dhcp.cid_type

Description This printer setting defines the type of client identifier (DHCP option 61) that will be sent if DHCP is enabled on the wireless print server. A value of "1" means the type of "Ethernet" and the printer’s MAC address will be used. A value of "0" or "2" means the client identifier sent will be "wlan.ip.dhcp.cid_prefix" concatenated with "wlan.ip.dhcp.cid_suffix". For printer support, see SGD Command Support

on page 315.

Type getvar; setvar

Note • For details on SGD command structure, see Command Structure on page 250.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with the client identifier
	type for the wireless print server.
	Format:
	! U1 getvar "wlan.ip.dhcp.cid_type"
setvar	This command instructs the printer to enable "synthetic" client identifier
	for the wireless print server.
	Format:
	! U1 setvar "wlan.ip.dhcp.cid_type" "value"
	Values:
	"0" = ASCII string
	"1" = wireless radio card’s MAC address
	"2" = HEX value
	Default Value: "1"

Example • This setvar example shows the value set to "1".

! U1 setvar "wlan.ip.dhcp.cid_type" "1"

What the setvar value is set to is the getvar result. In this example, the getvar result is "1".

14245L-003 Rev. A EPL Programming Guide 12/16/13