Zebra Technologies 14245L-003 manual 2D Bar Code QR Code Specific Options, Default Value a

EPL Commands

b

83

b

2D Bar Code – QR Code Specific Options

Description Japanese printer models only. Use this command to generate QR Code bar code symbols with a single command. See the AIM web site for QR Code specifications at http://www.aimglobal.org/

Syntax bp1,p2,p3,[p4-9]”DATA”

Parameters This table identifies the parameters for this format:

Parameters		Details
b =	Binary, xxxx	A four-digit decimal number specifying the number of bytes
		to follow.
p1 =	Horizontal start	Horizontal start position (X) in dots.
	position
p2 =	Vertical start position	Vertical start position (Y) in dots.
p3 =	Q	Must be “Q” for QR Code.

Parameters p4 through p8 are optional and may be omitted. Default values will automatically be inserted when a parameter is omitted. Each parameter value must be proceeded by its associated command prefix character. The parameters p4 through p8 can be inserted into the command string in any order prior to the “DATA” and following p3. Commas between parameters p4 through p8 are not required.

p4	= Code Model	Accepted Values:
	(prefix m)	1 = Model 1
		2 = Model 2
		Default Value: Model 2
p5	= Scale Factor	Accepted Values: 1–99
	(prefix s)	Default Value: 3
p6	= Error Correction	Accepted Values:
	Level	L = Lower error correction, most data
	(prefix e)	M = Default
		Q = Optimized for error correction over data
		H = Highest error correction, least data
		Default Value: M
p7	= Data Input Mode	Accepted Values:
	(prefix i)	A = Automatic Data Select
		M = Initialized the manual data mode and the data type is
		set by the first character in the fixed data field (“DATA”).
		Default Value: A

12/16/13 EPL Programming Guide 14245L-003 Rev. A