Zebra Technologies 14245L-003 manual Externalwired.ip.dhcp.cidall, 220

220

SGD Wired Commands

external_wired.ip.dhcp.cid_all

external_wired.ip.dhcp.cid_all

Description This printer setting defines the entire client identifier (DHCP option 61) if DHCP is enabled on the external print server and "external_wired.ip.dhcp.cid_type" is set to "0", or "2". The MAC address is used if the type is set to "1". For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Note • For details on SGD command structure, see Command Structure on page 216.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with the client identifier
	prefix and suffix of the external wired print server.
	Format:
	! U1 getvar "external_wired.ip.dhcp.cid_all"
setvar	This command instructs the printer to change the client identifier prefix
	and suffix of the external wired print server. The prefix gets cleared and the
	suffix contains the entire client identifier.
	Format:
	! U1 setvar "external_wired.ip.dhcp.cid_all" "value"
	Values: A maximum length of 60 characters if the CID type is ASCII, or
	120 characters if the CID type is hexadecimal.
	Default Value: ""

Example • This setvar example shows the value set to "printer".

! U1 setvar "external_wired.ip.dhcp.cid_all" "printer"

What the setvar value is set to is the getvar result. In this example, the getvar result is

"printer".

14245L-003 Rev. A EPL Programming Guide 12/16/13