Zebra Technologies 14245L-003 manual Character Substitution Euro, 129, Syntax oRp1,p2

EPL Commands

oR

129

oR

Character Substitution (Euro)

Description This command allows the advanced programmer to substitute the Euro currency character for any ASCII character in printer resident font numbers 1-4.

The second function this command supports is the zero character style toggling between a plain zero character and a zero with a slash.

Character substitution settings are stored in the printers non-volatile 'flash' memory. The original character can be restored by sending the oR command without a parameter.

Syntax oR[p1,p2]

Parameters This table identifies the parameters for this format:

Parameters	Details
p1 = E	If the p2 parameter is not provided, then the Euro character
	will map to code page position 213 decimal (D5 hexadecimal)
	for all code pages.
p1 = 0 (zero)	Toggles the zero character:
	slash — no slash (out of box default)
p2 = Decimal number	Accepted Values: 0 to 255
	The active code page’s ASCII character map position to be
	replaced by the Euro character. The Euro character will be
	active in this map position for all code pages. See the I
	command for details on code page selection.
None = No parameters	No Parameters (p1/p2) resets to all code pages to original
(p1/p2)	default character mapping.
	Optionally, to reapply normal character operations, issue a o
	(111 dec. or 6F hex.) command. See page 123 for important
	details on the effects of using this command.

Note • The Euro character is not supported in Font 5 character set.

12/16/13 EPL Programming Guide 14245L-003 Rev. A