Zebra Technologies 14245L-003 manual Wlan.ip.addr, 271, U1 setvar wlan.ip.addr

SGD Wireless Commands

wlan.ip.addr

271

wlan.ip.addr

Description This command allows you to get or set the wireless print servers’s IP address. For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Important • For a set IP address to take affect, the IP protocol must be set to permanent and the print server must be reset.

Note • For details on SGD command structure, see Command Structure on page 250.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with its current wireless
	print server IP address.
	Format: ! U1 getvar "wlan.ip.addr"
setvar	This command instructs the printer to change its current wireless print
	server IP address upon powering the printer on.
	Format: ! U1 setvar "wlan.ip.addr" "value"
	Values: any valid IP address
	Default: "0.0.0.0"

Note • The setvar value of this command can be affected by the wlan.ip.dhcp.enable command.

Example • This setvar example shows the value set to "10.14.4.235".

! U1 setvar "wlan.ip.addr" "10.14.4.235"

What the setvar value is set to is the getvar result. In this example, the getvar result is "10.14.4.235".

12/16/13 EPL Programming Guide 14245L-003 Rev. A