Zebra Technologies 14245L-003 manual Print Head Life Reminder Control, 329

Print Meter for 2746e and G-Series

oL

329

oL

Print Head Life Reminder Control

Description Use this command to customize the print head life reminder report. See the URR command to check the settings and status.

Syntax oL[p1,p2,p3]

Parameters This table identifies the parameters for this format:

Parameters		Details
No parameters		Resets the parameters to their default values for print head life
		reminder reporting.
p1 = Reminder Threshold		Sets the distance to be printed before a reminder label
		warning can be issued. Omitting or setting the value to 0will
		reset it to the default value of 50 kilometers.
		Default Value: 50 kilometers
		Accepted Values: 1–255; 1 = 1 kilometer
p2 = Frequency of		Sets the number of labels to be printed prior to issuing
Reminder		another reminder label.
		Omitting the parameter will reset it to the default. The 0 value
		causes the printer with the reminder enabled and in effect, to
		report a Reminder Message at power-up, error recovery, after
		a media out condition, a reset or after Cancel has been pressed
		on the printer.
		Default Value: 0 labels
		Accepted Values: 1–255; 1 = 1 label printed
p3 = Message “DATA”		Default Value: PRINTHEAD LIFE EXCEEDED
		Represents a fixed data field for a message of 39 characters or
		less. The message “DATA” is bound by quotes. See the EPL2
		programming ASCII Text (A) and the Character Set Selection
		commands for details on printing text.
Example •
oL40	; Sets the threshold to 40km, frequency and message are default
oL,5	; Sets the frequency to 5 labels, threshold and message are default

oL,,”Replace the print head”

;Sets the message to Replace the print head, threshold and

;frequency are default

12/16/13 EPL Programming Guide 14245L-003