Zebra Technologies 14245L-003 Externalwired.ip.gateway, 225, U1 setvar externalwired.ip.gateway

SGD Wired Commands

external_wired.ip.gateway

225

external_wired.ip.gateway

Description This command instructs the printer to change the external wired print server’s gateway address. For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Important • This setting refers to the gateway address. A set value is ignored if the IP protocol is not set to permanent.

Note • For details on SGD command structure, see Command Structure on page 216.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with the external wired
	printer server’s gateway address.
	Format: ! U1 getvar "external_wired.ip.gateway"
setvar	This command instructs the printer to change the external wired printer
	server’s gateway address.
	Format:
	! U1 setvar "external_wired.ip.gateway" "value"
	Values: Any valid gateway address
	Default: "0.0.0.0"

Example • This setvar example shows the value set to "10.3.5.1".

!U1 setvar "external_wired.ip.gateway" "10.3.5.1"

When the setvar value is set to "10.3.5.1", the getvar result is "10.3.5.1".

12/16/13 EPL Programming Guide 14245L-003 Rev. A