Zebra Technologies 14245L-003 manual Ip.lpd.enable, 189, U1 setvar ip.lpd.enable on

SGD Printer Settings

ip.lpd.enable

189

ip.lpd.enable

Description This printer setting refers to the LPD (Line Printer Daemon) protocol setting. For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Important • LPD communications from the host should be directed to port 515.

Note • For details on SGD command structure, see Command Structure on page 638.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with the LPD status.
	Format: ! U1 getvar "ip.lpd.enable"
setvar	This command instructs the printer to turn LPD on or off.
	Format: ! U1 setvar "ip.lpd.enable" "value"
	Values:
	"off" = disables LPD protocol
	"on" = enables LPD protocol
	Default: "on"

Example • This setvar example shows the value set to "on".

! U1 setvar "ip.lpd.enable" "on"

When the setvar value is set to "on", the getvar result is "on".

12/16/13 EPL Programming Guide 14245L-003 Rev. A