191
SGD Printer Settings
ip.pop3.password
12/16/13 EPL Programming Guide 14245L-003 Rev. A
ip.pop3.password
Description This printer setting refers to the POP3 mailbox password. This only applies if
"ip.pop3.enable" is set to on. For printer support, see SGD Command Support
on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure onpage 638.
Commands Details
getvar This command instructs the printer to respond with the POP3 password.
Format: ! U1 getvar "ip.pop3.password"
For protection a single "*" prints.
setvar This command instructs the printer to change the POP3 password.
Format: ! U1 setvar "ip.pop3.password" "value"
Valu e s : A maximum of 20 alphanumeric characters
Default: " "
Example • This setvar example shows the value set to "password".

! U1 setvar "ip.pop3.password" "password"

When the setvar value is set to "password", the getvar result is "*".