Zebra Technologies 14245L-003 manual Wlan.keepalive.timeout, 286, U1 setvar wlan.keepalive.timeout

286

SGD Wireless Commands

wlan.keep_alive.timeout

wlan.keep_alive.timeout

Description This printer setting manages the interval at which the LSAP (link service access point) packet is sent. For printer support, see SGD Command Support on page 315.

Type getvar; setvar

Note • For details on SGD command structure, see Command Structure on page 250.

This table identifies the commands for this format:

Commands	Details
getvar	This command instructs the printer to respond with the
	wlan.keep_alive.timeout interval value.
	Format: ! U1 getvar "wlan.keep_alive.timeout"
setvar	This command instructs the printer to configure the frequency at which the
	printer sends the wlan.keep_alive packet.
	Format: ! U1 setvar "wlan.keep_alive.timeout" "value"
	Values: 5 to 300 seconds
	Default: "15"

Example • This setvar example shows the value set to "15".

!U1 setvar "wlan.keep_alive.timeout" "15"

When the setvar value is set to "15", the getvar result is "15".

14245L-003 Rev. A EPL Programming Guide 12/16/13