Chapter 4 Installing the Operating System
Installing Windows Server 2003 or Windows 2000 Server
Step 3 Press Enter.
Step 4 Follow the
Using the Manufacturer-Provided Array-Configuration Utility
The server manufacturer provides a disc that contains utilities for several setup tasks, including configuring RAID arrays. Use the disc to configure the arrays when the Cisco Unity server was not purchased from Cisco.
The following discs are provided by server manufacturers:
|
|
IBM | IBM ServerGuide |
|
|
The following procedure contains only general steps. For detailed instructions on using a specific
To Configure the RAID Arrays by Using the
Step 1 Start the Cisco Unity server, and insert the manufacturer disc in the
Step 2 On the main menu, select the
Step 3 For each logical disk needed, group physical disks of the same make and model, and assign a RAID type.
For information on the recommended RAID configuration for the server, refer to the Cisco Unity Supported Platforms List, available at http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_data_sheets_list.html.
Step 4 Follow the manufacturer instructions to complete the configuration.
Installing Windows Server 2003 or Windows 2000 Server
If you are installing Windows Server 2003, you must use the manufacturer’s guided
Caution If you install Windows Server 2003, do not install Universal Description, Discovery, and Integration (UDDI) Services, or the Cisco Unity System Preparation Assistant will fail later in the installation process.
Installation Guide for Cisco Unity 4.0(5) and Later Voice Messaging with Microsoft Exchange 2003/2000 (With Failover Configured)
|
|
| |
|
|
