Installing Adjuncts

5 To connect an adjunct to an analog multiline telephone:

aConnect a 4-pair cord to the OTHER jack on the telephone.

bConnect the other end to the VT jack on a General Purpose Adapter (GPA).

cConnect the cord from the adjunct to the TEL/EQUIP jack on the GPA.

dGo to Step 7.

Refer to “General Purpose Adapter” below for additional information.

6lnsert the other end of the adjunct cord directly into the port for the logical ID on the 012 module as indicated on the system form. Go to Step 7.

7Test the adjunct by dialing its associated extension.

General Purpose Adapter

A General Purpose Adapter (GPA) lets you connect a T/R device--such as a single-line telephone or modem—to an analog multiline telephone. The device must be touch-tone, not rotary.

NOTES:

1.The GPA is intended for answer-only service, unless the telephone has direct access to a line. It does not have touch-tone receivers or pulse dial detectors; therefore, the associated analog muitiline telephone must dial calls.

2.The GPA cannot be used with a MERLIN II System Display Console.

3.When the system forms indicate a GPA for installation of an adjunct, follow the steps below.

1Plug one end of a 4-pair adjunct D8AC cord into the VT jack on the back of the GPA.

2Plug the other end into the OTHER jack on the underside of the analog multiline telephone.

3Plug the cord from the adjunct into the TEL EQUIP jack on the GPA.

3-24Installing Telephones and Adjuncts

Page 101
Image 101
AT&T 3.0 manual General Purpose Adapter, To connect an adjunct to an analog multiline telephone