Module Problems

Firmware on this circuit module can be upgraded or reinstalled with an Upgrade memory card. An upgrade is performed when a new release of firmware enhances a module’s capabilities or corrects problems. Firmware can be reinstalled if the existing circuit module firmware has been corrupted.

Summary

Console Procedure

PC Procedures

Appropriate Modules

Time Estimate Busy-Out or Reset

Restore

Menu Maintenance Slot Dial the slot

no. Enter Upgrade Yes

(F6)(F2)Type the slot no. (F10)(F8)or (F10)(F4)

This procedure can be run only on the 800 LS-ID module or modules introduced after Release 3.0.

Approximately 1.5 minutes.

The module is automatically busied-out after the upgrade procedure begins.

If Busy-Out is unsuccessful, you are given the option of waiting for a Busy-Out or selecting Reset.

Restore the module after the upgrade successfully completes. Restore is in the Slot menu, which you can access by doing the following from the console:

Menu Maintenance Slot

See "Restore,” earlier in this chapter, for additional information.

Control Unit Problems 4-61

Page 439
Image 439
AT&T 3.0 manual Summary