AT&T 3.0 manual System Forms

System Forms

5.Connect the control unit to the network interface (required).

6.Connect the channel service unit (CSU) to the 100D module on the control unit (required only with the 100D module).

7.Connect the printer and PC to the control unit (optional).

8.Connect data equipment to the control unit (optional).

9.Initialize and test the system (required).

10.Install the control unit housing (required).

11.Install applications (optional).

A list of required tools and equipment is given before each installation procedure.

System Forms

Some of the installation procedures in this guide refer to system forms. These forms indicate information that is specific to your customer’s system. The forms you need should be included with the system programming disk or memory card, which contains all of the programming specifically for your customer’s system.

If you are upgrading an existing system and do not have the required forms for your customer’s system, you can load System Programming and Maintenance (SPM) and print out the required forms.

If you find that you do not have a completed set of system forms for your customer’s system, contact your technical support organization or the Customer Service Center (CSC). See the inside front cover for telephone numbers.

The system forms that you need are specific for each system, and include some or all of those described in the following sections.

1–2Introduction