AT&T 3.0 manual Error Conditions During Firmware Upgrade, Memory Card In Use By Another Feature

Module Problems

One of the following screens appears when the upgrade has successfully completed. If only a Restore is required to put the module back into service, the screen below appears.

Console Display/Instructions Additional Information P C

Upgrade Slot xx:

Upgrade Successfully

Completed.

Slot Busied Out.

Slot Restore needed.

Exit (F5)

If a Board Renumber is also required, the screen below appears.

Upgrade Slot xx:

Upgrade Successfully

Completed.

Slot Busied Out.

Board Renumber needed.

Exit (F5)

Perform a Board Renumber and/or Restore as indicated above.

Error Conditions During Firmware Upgrade

The following error conditions can occur during a firmware upgrade. Recovery procedures follow each error condition.

Memory Card In Use By Another Feature

Module Upgrade:

Memory Card in use by another feature

Exit (F5)

Select Exit and begin the upgrade procedure again.

4-66Control Unit Problems