AT&T 3.0 manual Error Codes Description Action, Full

Error Logs

Table 2-2 Continued

Error

Codes Description

Action

1C03

FW

UPGRADE

COMPLETE

No action

required.

3001

ALARM

TABLE

FULL:

Correct indicated errors, and then

The error logs are full, and no more

remove entries from the transient system

errors can be added to them.

error log to free up space. If problem

Turns on

the

processor

LED.

persists, cold-start the system before

continuing

with

troubleshooting.

Sys Program →System-Restart

4401

USER REQUESTED SYS ERASE:

If this error

remains in the transient log,

This error is logged after a System

do the System Erase again. If problem

Erase. If the System Erase is

persists,

troubleshoot the processor.

successful, this error is removed

immediately.

6C01

DS1 LOSS OF SIGNAL ALARM:

Troubleshoot the T1 trunk. If problem

Service

on

the link has

been lost.

persists, check the channel service unit

(CSU) and the cable between the CSU

and the 100D module. If problem

persists, escalate to your technical

support

organization.

6C02

DS1

BLUE

ALARM:

The far

end of

the network interface is out

All

ones being received

Service on

of service. Troubleshoot the T1 trunk,

the

link

has been lost.

channel service unit (CSU), and the

cable between the CSU and the 10OD

module. If problem persists, escalate to

your technical

support organization.

6C03

DS1 RED ALARM:

Troubleshoot the T1 trunk. If problem

Incoming signal does not have valid

persists, escalate to your technical

framing

information.

support

organization.

Service

on

the link has

been lost.

Continued on next page

Error Logs, Access Logs, and System Inventory 2-9