AT&T 3.0 manual 8Error Logs, Access Logs, and System Inventory

Error Logs

Table 2-2 Continued
	Error			Action
	Codes	Description
0012		INVALID RESET FLAG:		Troubleshoot		the	processor.
		Processor	problem.
0013		DUART STREAMING INT:		Troubleshoot		the	processor.
		Processor	problem.
0014		PROCESSOR	ERR INTERRUPT:	Troubleshoot		the	processor.
		Processor	problem.
0015		MODULE MISMATCH:		Change system programming to reflect
		Physical and logical type mismatch.		the proper module or install the proper
		Module inserted into wrong slot.		module.
0016		POWER UP	COLD START:	If problem persists, troubleshoot the
		A module dual port RAM failure was		module for	the slot, indicated.
		detected.
		System programming is okay.
	0C01	NO I-VMS PORT IN SERV:		No action	required.
		This error indicates that the VMS
		machine may be down.
	0C02	DID INTERDIGIT TIMEOUT:		No action required. If problem persists,
		May be noisy line or central office		troubleshoot the DID line and inform the
		problem.		central office		if necessary.
	1CO1	POOL M-BUSY EXCEEDS 50%:		Troubleshoot		trunk.
		More than half the trunks in the pool are
		busy.
	1C02	FW UPGRADE ATTEMPT		If FW UPGRADE ATTEMPT is logged and FW
				UPGRADE COMPLETE is not, the firmware
				upgrade should be retried. The circuit
				module should be considered unreliable
				until a successful			upgrade is performed.

Continued on next page

2-8Error Logs, Access Logs, and System Inventory