AT&T 3.0 manual Connecting a Printer 50 Feet Or More Away

Connecting a Printer to the Control Unit

Connecting a Printer 50 Feet

(15.2 m) or More Away

Use this procedure to connect a printer to the control unit if the following conditions apply:

The printer is not a CAT printer connected to a CAT.

The printer is 50 ft. (15.2 m) or more from the control unit.

The printer is not grounded to the same AC outlet as the control unit. The printer is not grounded to an outlet that is on the same

117-V AC branch as the control unit and that is 50 ft. (15.2 m) or closer to the control unit.

NOTE:

If you are installing the printer in a different room than the control unit, make sure that both locations have working wall outlets and wall jacks, and that the building wiring has been connected so that the wall jacks in each location communicate with each other.

You need the following hardware for this procedure:

Z200A EMI filter

Adapter for the interface cable connector

—355A for the male connector

—355AF for the female connector 400B2 power adapter

Z3A2 ADUs

BRIA-4P adapter or 102 connecting block or 103 connecting block 8-position wall jacks

EIA crossover cable ADU crossover cable 2012D transformer

Installing the PC, CAT, or Printer 5-17