AT&T 3.0 manual Testing the Dictation System, Testing the Paging System

Testing the System

c Hang up the handset.

d Press the Recall button and dial the password. (On an MLX telephone without a programmed Recall button, press the Feature button and dial

775and the password before picking up the handset.) e Pick up the handset and make an outside call.

f Verify that you have good two-way communication and hang up.

9At the operator console, press the Night Service button again. If you used a password in Step 1, enter the password again. Verify that the Night Service LED turns off.

Testing the Dictation System

If dictation equipment has not been installed, skip this test. Place a call to verify that you can access the dictation system.

To access the dictation system, follow the steps below:

1At the test telephone, pickup the handset.

2Dial the access code and the number associated with the dictation equipment.

3Verify that the ready tone is transmitted.

4Test the transmission in both directions; make a recording and play it back.

5Hang up.

Testing the Paging System

To test the paging system, follow the steps below:

1Pick up the handset at the test telephone and dial the number for a particular zone

If ZoneMate 9 paging equipment is in use with PagePac 20, get an acknowledge tone first and then dial the zone code to make an announcement. You may hear a confirmation tone.

7–16Initializing and Testing the System