Installing the Processor

CAUTION:

Before touching leads, connectors, pins, and other components when handling the circuit board, use a properly grounded wrist strap to prevent damage from electrostatic discharge (ESD).

Installing the Processor in the Carrier

To install the processor in the carrier, follow the steps below, Refer to Figure 2-10.

1Remove the protective cover from the gold-finger connector on the back of the processor.

2Lower the hook on top of the processor module onto the rod on top of the carrier in Slot 0, the first slot next to the power supply.

3Make sure that the connector on the module mates properly with the connector on the carrier as you swing the processor down into place.

CAUTION:

To avoid damage, do not force the module. If the module does not insert easily, press the bottom rear locking tab, remove the module, and inspect the module and carrier for damage or obstruction. The bottom- rear locking tab is shown in Figure 2–10.This tab is used on all modules.

If there is no damage and no obstruction, reinsert the module.

A damaged carrier or module must be replaced.

4Push firmly until the processor snaps into place.

The processor should be securely attached to the carrier and locked in place by the locking tab on the bottom rear of the processor.

2-30Installing the Control Unit

Page 61
Image 61
AT&T 3.0 manual Installing the Processor in the Carrier, Push firmly until the processor snaps into place