AT&T 3.0 manual Menu →Maintenance →Slot

Module Problems

Busy-Out or Reset

Interrupting the Test

Test Failure

Restore

Busy-out or reset the module being tested prior to beginning the test. Both Busy-Out and Reset are in the Slot menu, which you can access by doing the following from the console:

Menu →Maintenance →Slot

See “Busy-Out and Reset,” earlier in this chapter, for additional information.

You can interrupt the test (both Test Once and

Repetitive) by selecting Exit.

If the test fails, record the errors on the repair tag and replace the module.

Restore the module if it successfully completes all module tests and the errors no longer occur. Restore is in the Slot menu, which you can access by doing the following from the console:

Menu →Maintenance →Slot

See the “Restore” procedure, earlier in this chapter, for additional information.

To run the Internal Loopback Module Test, follow the steps below.

Console Display/Instructions Additional Information PC

1 From the Maintenance menu, select the Slot option.

Maintenance

Make a selection

System

Slot

Port

Exit

(F2)

4-46Control Unit Problems