AT&T 3.0 manual FCC Notification and Repair Information

Customer Support Information

FCC Notification and Repair

Information

This equipment is registered with the FCC in accordance with Part 68 of its rules. In compliance with those rules, you are advised of the following:

Means of Connection. Connection of this equipment to the telephone network shall be through a standard network interface jack, USOC RJ11C, RJ14C, RJ21X. Connection to E&M tie trunks requires a USOC RJ2GX. Connection to off-premises extensions requires a USOC RJ11C or RJ14C. Connection to 1.544-Mbps digital facilities must be through a USOC RJ48C or RJ48X, Connection to DID requires a USOC RJ11C, RJ14C, or RJ21X. These USOCs must be ordered from your telephone company.

Party Lines and Coin Telephones. This equipment may not be used with party lines or coin telephone lines.

Notification to the Telephone Companies. Before connecting this equipment, you or your equipment supplier must notify your local telephone company’s business office of the following:

—The telephone number(s) you will be using with this equipment.

—The appropriate registration number and ringer equivalence number (REN), which can be found on the back or bottom of the control unit, as follows:

❑If this equipment is to be used as a Key system, report the number AS593M-72914-KF-E.

❑If the system provides both manual and automatic selection of incoming/outgoing access to the network, report the number AS593M-72682-MF-E.

Maintenance and Troubleshooting A–3