AT&T 3.0 Console Display/Instructions Additional Information P C, Observe the status screen below

Module Problems

If the firmware selected provides functionality that is different from the circuit module’s current firmware, the Maintenance display indicates that a Board Renumber will be required once the installation is complete.

Console Display/Instructions	Additional Information P C
Upgrade Slot xx:	xx = slot number entered in Step 3
Slot will be Busied Out.
Renum board when done.
Do you want to continue?
Yes
No
Exit	(F3)

If the module Busy-Out is blocked by an active line or extension, the following screen appears.

7 Choose to wait for the module to busy-out or reset the module.

Slot xx in Use:

Make a Selection

Continue Busy-Out

Reset

Exit

8 Observe the status screen below.

xx= slot number entered in Step 3

Continue Busy-Out does not intrrupt calls in progress, but Reset does.

(F1)

(F2)

See the next section, “Error Conditions During Firmware Upgrade” if error messages appear.

Upgrade Slot xx:

In Progress

xx % Completed

Control Unit Problems 4-65