AT&T 3.0 manual Marking the Basic Carrier Screw Holes

Installing the Basic Carrier

To install the basic carrier, follow the steps below:

1Mark the screw-hole locations on the backboard, using the basic carrier or the template supplied with the plastic preassembled backboard as a guide. See Figure 2-5.

Make sure the carrier is level before marking the holes.

2Drill a pilot hole in the center of each of the four screw-hole marks.

3Anchor the screws approximately halfway into the backboard.

4Position the carrier on the screws and slide the carrier to the left.

5Tighten the screws.

Mounting Surface

Mounting ‘\ ‘

Screw \

\

Backboard

B a s i c

Carrier

Figure 2-5. Marking the Basic Carrier Screw Holes

2-18Installing the Control Unit