AT&T 3.0 manual Frigid Start System Erase

Maintenance Strategy

Frigid Start (System Erase)

CAUTION:

All system programming is erased. When you perform a frigid start (System Erase), all calls are dropped, and the system configuration information is erased. All system memory must be reinitialized, including system programming. Then the entire system must be rebooted.

To perform a frigid start, select System Erase as follows:

Console Procedure	Menu →Maintenance →Slot →Dial 00 →Demand
	Test → System Erase (Line 5 of the display, left
	button) →System Erase			→Yes
PC Procedure	→	→	→	→	→	→
	(F6) (F1)	Type 00	(F2) (F3)		(F3)	(F2)

Considerations

■System Erase is not displayed on the MLX-20L status display. To select System Erase, press the left button on Line 5 of the display twice.

■After a System Erase, the default printer is the PC printer, not the Station Message Detail Recording (SMDR) printer. If you want on-site printouts from the SMDR printer, make sure you change the option.

To change the printer option, see System Programming and Maintenance (SPM) for information on the Print Opts option on the SPM Main Menu.

For more information on System Erase, see “Processor Problems” in Chapter 4.

1–22Introduction