AT&T 3.0 manual Initializing and Testing System, Initializing the System

Initializing and Testing

the System 7

When you have finished installation, you are ready to initialize the system as described in this chapter.

Initializing the System

To initialize a Release 3.0 system, use one of the following methods:

Restore from a 3.0 system programming disk or Translation memory card.

Upgrade to Release 3.0 from Release 1.0, 1.1, 2.0, or 2.1. See Chapter 9, “Upgrading the System.”

Use system programming forms and the procedures from one of the guides listed in the next section, “Programming Guides”.

This section describes how to restore the system from the Translation memory card or the system programming disk.

NOTE:

On initial installations, make sure you perform a System Erase (frigid start), as described in Maintenance and Troubleshooting, immediately before you restore from a disk or memory card or before you program the system. Failure to perform the System Erase (frigid start) can result in incorrect programming.

Initializing and Testing the System 7–1