AT&T 3.0 manual On Hook Before Ready

Error Logs

Table 2-2 Continued
	Error		Action
	Codes Description
8405		ON HOOK BEFORE READY:	Troubleshoot the far end of the network
		Outbound dialing problems on tie	interface to see whether it is working and
		trunks. For a tie trunk with delay dial	translated properly. Troubleshoot for wink
		or wink start, the far end of the	start	and faulty	cable. Troubleshoot the
		network interface went on-hook	far end of the network. Replace the
		before the guard time elapsed.	module.
8406		INTERDIGIT TOO SHORT:	Troubleshoot the far end of the
		Inbound dialing problems on tie and	network interface to see if it is working
		DID trunks.	and	translated	properly.	Troubleshoot
			for faulty cable.		Replace	the module.

8407 BAD UPDATE:

communication problems occurred between the processor and the modules. Module may need to be replaced.

Turn the processor off and then on. Repeat system programming procedure. [f problem persists, escalate to your technical support organization.

8408 ROTARY RATE > 12PPS:

Inbound dialing problems on tie and DID trunks.

Troubleshoot the far end of the network interface to see if it is working and translated properly. Troubleshoot for faulty cable. Replace the module.

8409 ROTARY RATE < 8PPS:

Inbound dialing problems on tie and DID trunks.

Troubleshoot the far end of the network interface to see if it is working and translated properly. Troubleshoot for faulty cable. Replace the module.

840A BAD DOWNLINK MESSAGE:

Communication problems occurred between the processor and the modules, The module received an unrecognized message from the processor.

Turn the processor off and then on. Repeat system programming procedure. If the problem persists, replace the module.

Continued on next page

2-16Error Logs, Access Logs, and System Inventory