AT&T 3.0 manual Card Failure, Restore

Backing Up with a Memory Card

CAUTION:

The memory card may be write-protected to avoid the accidental erasure of the backup files. Make certain this is not the case before you change the write-protect tab.

Card Failure

Memory Card Backup:

Backup Failure

Try a different file or a new Memory Card.

Exit

If the card is damaged, repeat the backup with a different card. If a backup is in progress and fails, the system makes two additional attempts at the backup. At the start of each attempt, a message appears with the percentage of the backup that is completed. lf the backup fails after three attempts, the screen shown above appears. Repeat the backup procedure using a different file and/or memory card.

Restore

Use this procedure to restore system conditions that were backed up onto a translation memory card. The information in a backup file on the translation card is copied to the system.

The restore procedure is necessary under the following conditions:

System RAM is corrupt.

A previously stored set of system conditions is preferred over the current set.

The processor module is replaced.

After a System Erase (frigid start) has been performed.

The system software has been reinstalled.

D–18Maintenance and Troubleshooting