Connecting a Printer to the Control Unit

248B adapter

D8W cords

D6AP power cord

EIA-232-D cable

4-pair plug-ended cable

To connect a printer 50 ft. (15.2 m) or more away from the control unit, follow the steps below. See Figure 5-6.

1Plug the short end of a Z200A EMI cord into the SMDR jack on the control unit.

2Plug the other end of the Z200A EMI cord into a 355AF adapter.

3Plug the female end of the 355AF adapter into one end of an EIA crossover cable.

4Plug the other end of the EIA cable into the 25-pin male connector of the Z3A2 ADU.

CAUTION:

If the printer is in a building outside the main building (control unit location), you must install an ADU and an additional protector in each building. The ADUs and protectors provide both the control unit and the printer with additional protection against lightning, inadvertent contact with power lines, and power currents induced by nearby power lines. See the installation notes packaged with the ADU for more information.

5Plug one end of a D8W cord into the WALL jack on the Z3A2 ADU.

6Plug the other end of the D8W cord into an ADU crossover cable.

7Plug the other end of the ADU crossover cable into one of the jacks on a 400B2 power adapter.

8Plug one end of a D6AP cord into the other jack of the 400132 adapter.

5-18Installing the PC, CAT, or Printer

Page 177
Image 177
AT&T 3.0 manual 18Installing the PC, CAT, or Printer