MLX Telephone Tests

Cancel the Call Forwarding feature (for the receiving telephone):

On multiline telephones, press the Feature button and dial *34*.

On single-line telephones, pick up the handset, dial #*34*, and then hang up.

NOTE:

You can cancel Call Forwarding from the receiving telephone or from the forwarding telephone, providing that you know the number.

MLX Telephone Tests

If the LEDs, ringer, buttons, switchhook, or display appear not to be working, try the steps below.

1Pickup the handset.

2When you hear dial tone, press *00 (the feature access code).

The telephone enters test mode. For some tests, this means the LEDs turn on; for others, it means the phone starts ringing.

This test connects a test tone to the B-channel and sends a repeated ring burst to the telephone.

On an MLX telephone with a DSS attached, all LEDs light and the phone rings throughout the test.

On an MLX display telephone, the display blanks out and is replaced with a grid of small dots.

3Press each line/feature button (two LEDs each). The red and green LEDs should toggle on and off.

4Press each fixed-feature button that has an LED (Feature, HFAI, Mute, and Speaker).

Each LED should toggle on and off.

NOTE:

Mute and Speaker LEDs may not toggle consistently because they are managed by the control unit and the telephone.

3-6Telephone Problems

Page 374
Image 374
AT&T 3.0 manual MLX Telephone Tests