AT&T 3.0 manual 16Introduction

Preparation for Hardware Maintenance

■If you have a MERLIN LEGEND Communications System (Release 2.0 or earlier):

1.Pry the clips from the housing on both sides of the control unit; use a screwdriver if they are difficult to remove.

2.Carefully pull the housing towards you.

NOTE:

If the MERLIN LEGEND (Release 2.0 or earlier) system has more than one carrier, make sure you hold the housing assembly on the basic carrier at the sides, otherwise, the housing may disassemble as the front and side panels are only slotted together.

MERLIN II and

MERLIN LEGEND 2.1 and later

Communications System

MERLIN LEGEND 2.0

and earlier

Communications System

Housing

C l i p

Housing

Figure 1-5. Removing the Control Unit Housing

1–16Introduction