Testing the System

2Pick up the handset. (In Hybrid/PBX systems with pooled tie trunks, press an SA button and dial the pool dial-out code.)

The green LED next to the selected button lights.

3Dial the tie-trunk number of the extension where someone is waiting for your call.

You should hear ringing,

4When the person answers, verify that you have good two-way communication, then hang up.

The green LED should turn off, the red LED should turn off, and another red LED may turn on.

5Repeat Steps 1 through 4 for each outgoing or two-way dial-repeating tie trunk.

Testing Selected System Features

This section provides procedures to test the following system features:

Automatic Route Selection (ARS). For Hybrid/PBX mode only. Use the same test for Idle Line Preference, a similar feature used in Key mode only. Use the same test for Station Message Detail Recording (SMDR) as explained in the test procedure. Refer to Planning Forms 3e, 3f, and 3g for ARS information.

Group Calling. Use the same test for the Listed Directory Number (the QCC queue), which is for Hybrid/PBX only. Use the same test for Group Paging. Refer to Planning Form 7d for Group Calling information.

Coverage. Refer to Planning Form 7c for Group Coverage information.

If any feature does not work properly, check system programming. You can run these tests easily from an MLX telephone or an analog multiline telephone.

7-12Initializing and Testing the System

Page 217
Image 217
AT&T 3.0 manual Testing Selected System Features