AT&T 3.0 manual Modifying a Release 2.1 or Earlier Processor for Key Mode, Release 2.1 and Earlier

Modifying a Release 2.1 or

Earlier Processor for Key Mode

E

Release 2.1 and Earlier

CAUTION:

This procedure must be performed for KF registration with the FCC.

This procedure prevents the system from being programmed as a Hybrid-PBX system. Do this only if the system is programmed for Key mode and GS trunks are not indicated on Form 2c, System Numbering: Line/Trunk Jacks.

To modify the processor for Permenant Key mode, follow the steps below. Refer to Figure E-1.

1Remove the processor from its packaging.

2Place the processor on a flat surface.

3If the feature module is installed, remove it.

See “Replacing the Feature Module” in Chapter 4 for instructions.

Maintenance and Troubleshooting E–1