Canon MultiPASSTM C50 manual Problems Feeding Paper into the Sheet Feeder

Problems Feeding Paper into the Sheet Feeder

If you are having problems feeding paper or other media into the MultiPASS C50's sheet feeder, check the following table.

Whenever you correct one of these problems, be sure to remove the paper from the sheet feeder and load it again. See page 2-45.

The following problems can also cause the paper to jam in the unit. See page 8-6 for instructions on clearing paper jams.

Problem Possible cause Solution

Paper does not feed into the MultiPASS C50 sheet feeder

The sheet feeder may contain too many sheets.

Make sure the sheet feeder is not ®lled past the limit mark (). See page 2-47.

Paper may not be inserted in the sheet feeder correctly.

Make sure paper is inserted all the way into the sheet feeder. See page 2-45.

Printing is skewed	Paper may not be stacked
	correctly in the sheet feeder.

Make sure the stack of paper is straight in the sheet feeder.

Make sure the right side of the stack of paper is aligned with the right side of the sheet feeder, and that the paper guide is aligned against the left side of the stack. See page 2-47.

Make sure the paper exit path is clear.

Chapter 8 Troubleshooting 8-9