Making Connections

Connecting the MultiPASS C50 to Your PC

Your MultiPASS C50 has an 8-bit, bi-directional parallel interface port that allows you to connect it to your PC.

Use the parallel cable and ferrite core provided with your MultiPASS C50. If you plan to use a cable or ferrite core other than those provided, make sure they are IEEE 1284 compliant and that the cable is preferably no longer than two metres.

Connect the MultiPASS C50 to your computer as follows:

1.Make sure the computer is turned off and the MultiPASS C50 is unplugged.

2.Connect the parallel cable to your MultiPASS C50:

a.Align the cable connector with the interface port so their shapes match.

b.Gently press the cable connector into the port.

c.Secure the cable connector by snapping both wire clips (on the sides of the port) into the cable connector, as shown below.

2-14Setting Up Your MultiPASS C50

Chapter 2

Page 40
Image 40
Canon MultiPASSTM C50 Making Connections, Connecting the MultiPASS C50 to Your PC, 14Setting Up Your MultiPASS C50 Chapter