Printing on FS-101 Fabric Sheets

Follow these steps to load and print on Canon's FS-101 fabric sheets.

JRead and follow the precautions and handling instructions included with the FS-101 fabric sheets.

JDo not use the ®xing agent that is supplied with the FS-101 fabric sheet. This agent is not needed when printing with the MultiPASS C50.

JDo not touch the printing on a newly printed fabric sheet until the ink has dried completely (normally about an hour).

1.Open the printer cover by grasping the document guides and lifting.

J Make sure the paper thickness lever is set to the right. See ºAdjusting the Paper Thickness Leverº on page 2-42.

2.With the cloth side facing you and the open end up, insert one sheet into the sheet feeder until it stops, and align the paper guide with the edge of the sheet. You are now ready to print.

OPEN END AT THE TOP

2-52Setting Up Your MultiPASS C50

Chapter 2

Page 78
Image 78
Canon MultiPASSTM C50 manual Printing on FS-101 Fabric Sheets, 52Setting Up Your MultiPASS C50 Chapter