
| Things To Keep In Mind When You Adjust the Print Position: |
Print jobs with data closer than 20 mm (about 1 inch) to the fold perforation or | |
from the edges of the forms do not have the full adjustment range. For | |
example, if the job has data that prints 10 mm (about ì inch) from the fold | |
perforation, the maximum amount that image can be shifted is 10 mm (ì inch) | |
toward the page perforation. If you attempt a larger vertical adjustment, Print | |
Error Marker (PEMs), which the host system turns on or off, can occur. |
|
| |
Direction |
| V=0 |
| H=0 | |
|
| |
Process | +480 | |
|
| |
|
| +480 |
Figure 21. Factory Set Default Registration
HC6OG075
Note: The horizontal (H) and vertical (V) values vary depending on the print
| resolution (PEL) that you selected for the printer. |
| How This Procedure Works: |
| Doing this procedure lets you change the point of origin on a page by adding |
| to or subtracting from the vertical and horizontal starting positions. |
| Figure 21 illustrates the default point of origin (vertical=0, horizontal=0). It also |
| shows the range of possible adjustments, which are not drawn to scale, when |
| the print resolution is set to 480 DPI. The maximum adjustment in any |
direction from this position is about 6 inches. | |
Note: The InfoPrint 3000 printers show a range of either ±2880 for 480 DPI or | |
±3600 for 600 DPI. | |
What If the Adjustment Required Is Out of Range: | |
| If more than 20 mm adjustment (from 0) is required, refer the application |
| owner to the Forms Design Reference for Continuous Forms Advanced Function |
| Printers. |
| The vertical and horizontal adjustment directions are always relative to the |
| process direction (the direction that forms are moving through the printer). The |
| vertical adjustment moves the point of origin on a line parallel to the forms |
Chapter 6. Operator Responsibilities 71