Stacker Control Panel
The stacker control panel is just above the stacker. The controls allow you to raise and lower the stacker table, stop the movement of the stacker table, advance the forms, and select the type of form being used. The panel also indicates with lights the length of the forms being used, which is set by the Forms Length Control (see ªForms Length and Width Controlsº on page 30).
Table Forms
Feed
| Up |
|
|
| Forward |
|
|
| STOP |
|
|
| READY |
|
|
| Down |
|
|
| Stop |
|
|
|
| Forms Select |
| ||||
|
|
| A |
| |||
|
|
| B | ||||
|
|
| C Plastic |
|
|
| |
Forms Length |
|
|
| ||||
7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 |
0 |
| 1/3 |
| 1/2 |
| 2/3 |
|
Figure 2. Stacker Control Panel
Using This Control: Does This:
HC6OG004
Makes the complete system (both printers) Ready when the printing system is in duplex mode, or makes the individual printer Ready when the system is in dual simplex mode. If pages are waiting to be printed and the system or printer is online to the host, printing begins.
Finishes the page that is currently being printed and makes the printing system (both printers) Not Ready in duplex mode or the individual printer Not Ready in simplex mode.
