Table 16. Printer Con®guration Items (continued)
Con®guration Item | Description | Value Options |
|
|
|
NPRO Length | This entry sets an extra length that is added to the ®xed | Range of 0 to 1200 inches. |
| NPRO length to create a total distance that forms are |
|
| moved through the printer. |
|
| This entry can be used when an uncoupled (not |
|
| functionally attached) postprocessing device is installed |
|
| and it is necessary to extend the NPRO length to be able |
|
| to easily remove forms at the postprocessing device |
|
| output. |
|
| If any installed and enabled |
|
| preprocessing/postprocessing devices have the |
|
| ªPre/postprocessor Extended NPROº distance of an |
|
| enabled pre/postprocessor set to greater than zero, then |
|
| that distance will take precedence over the ªNPRO |
|
| Lengthº, even if the ªNPRO Lengthº is longer. The |
|
| ªPre/postprocessor Extended NPROº distance is set in |
|
| the Con®gure Pre/Post procedure. If several |
|
| ªPre/postprocessor Extended NPROº distances are set, |
|
| then the longest one takes precedence. |
|
|
|
|
Auto NPRO at End | This entry indicates whether an automatic NPRO is | Yes or No |
of Forms | performed when an End of Forms is detected. |
|
|
|
|
Jam Recovery Point | This entry sets a distance past the printer fuser sufficient | Range of 0 to 500 inches. |
Distance | for forms to reach an installed postprocessing device, so |
|
| that those forms will be reprinted following a forms jam |
|
| recovery. |
|
| In duplex mode, this distance is measured past the fuser |
|
| of Printer 2. In dual simplex mode, it is a distance past |
|
| either Printer 1 or Printer 2. |
|
| A |
|
| device is installed and enabled, the ªJam Recovery Typeº |
|
| con®guration item setting above allows reprinting of |
|
| pages, and the ªDirect Attachº con®guration item setting |
|
| above is No. |
|
|
|
|
Form Feed Length | This entry sets the length, in inches, that forms are to be | Range of 17 to 250 inches. Default |
(D) | moved forward through Printer 1 when the Feed Forms | is 60 inches. |
| pushbutton is selected during execution of the |
|
| Thread/Align Forms procedure in duplex mode. |
|
|
|
|
Length of Forms | This entry sets the length, in inches, of the forms path | Range of 150 to 800 inches. |
Between Transfer | length from the alignment mark on the transfer station | Default is 315 inches. |
Points (D) | tractors of Printer 1, through Printer 1, across the ¯oor to |
|
| the Buffer/Flipper Unit, through the Buffer/Flipper Unit, |
|
| across the ¯oor to Printer 2, under Printer 2 up to the |
|
| alignment mark on the transfer station tractors of Printer |
|
| 2. This is used during the duplex mode procedure |
|
| Thread/Align Forms. If you are continually feeding |
|
| paper at either printer in order to get the forms aligned, |
|
| this con®guration item may have to be changed. |
|
| See ªAppendix B. Physical System Layoutsº on page 293 |
|
| for physical layout details and dimensions. |
|
|
|
|
Chapter 8. Con®guring the System 223
