IBM 3000 manual Ordering and Replacing Supplies

9.Put the ®ne ®lter in the ®lter housing. Ensure that the ®ne ®lter is completely in the ®lter housing.

10.Return the ®ne ®lter housing to its upright position in the recess.

11.Lower the ®lter cover and secure the latch.

12.Close the right rear cover of the printer.

13.To resume processing, SELECT the Ready pushbutton on the Display Touch Screen.

14.If the CHECK FINE FILTER message appears, the ®ne ®lter may not be pushed all the way into the ®lter housing. Adjust the ®ne ®lter, then repeat step 13. If that does not correct the problem, contact your service representative. See ªService Call Procedureº on page 13 for instructions.

Chapter 7. Ordering and Replacing Supplies 203