IBM 3000 manual These errors are not set when a, Postprocessing Device Interface feature

Table 12. Jam Recovery Procedures - Simplex Mode (continued)

Error Message SRC Code (In Numeric
Order)		Recovery Actions
STACKER FORMS JAM	0161	1.	Visually check to see if a forms jam is actually present.
STACKER FORMS JAM	0164
		2.	Open the stacker gate.
(These errors are not set when a
		3.	If you do not ®nd a jam, clean the stacker jam sensors. See step 30
Postprocessing Device Interface feature
			on page 98 under ª Cleaning the Printer.º
is installed and enabled, which disables
			Go to step 5.
the stacker mechanism.)
		4.	If you ®nd a jam, clear forms from the ªStacker and Pendulum
			Areaº on page 143.
			Note: When you remove the forms from the stacker, leave 4 to 5
			pages attached to the end of the job running in the stacker to ensure
			correct forms folding when printing resumes.
		5.	Close the stacker gate.
		6.	If either Printer Error stacker jam message is still displayed,
			SELECT the Check Reset pushbutton on the Printer Error Display
			Touch Screen window.
		7.	Check for and resolve or postpone any other error or intervention
			message appearing on the Display Touch Screen window.
		8.	Ensure that the Forms Set indicator on the printer control panel
			displays the same fold direction as the ®rst fold below the
			perforations on the forms guide.
		9.	SELECT the Ready pushbutton on the Display Touch Screen
			window for the affected printer.
		10.	If reprinting is allowed, all unfused pages between the transfer
			station and the top of the stacker plus any jam recovery point
			distance de®ned in the printer con®guration are reprinted. Check for
			and discard duplicate pages.
		11. If reprinting is not allowed, work with the host system console
			operator to recover the lost pages.
		12.	See ªSuggestions for Preventing Jamsº on page 144 if the error
			recurs frequently.

Chapter 6. Operator Responsibilities 125