Appendix A. Valid Form Lengths in Inches

Table 31. Examples of Some Valid Form Lengths in Inches

	Use this value at the	Use this value at the Stacker
If the Form Length is:	Display Touch Screen:	Control Panel:

3.0	3.0	See note 2

3ì	3.5	See note 2

4.0	4.0	See note 2

4ì	4.5	See note 2

5.0	5.0	See note 2

5ì	5.5	See note 2

6.0	6.0	See note 2

6ì	6.5	See note 2

7.0	7.0	7.0

7ì	7.5	7ì

8.0	8.0	8.0

8å/B	8.1	See note 1

8å/<	8.3	8å/<

8ì	8.5	8ì

8æ/<	8.6	8æ/<

See note 1	8.8	See note 1

9.0	9.0	9.0

9ì	9.5	9ì

10.0	10.0	10.0

10ì	10.5	10ì

11.0	11.0	11.0

11ì	11.5	11ì

12.0	12.0	12.0

12ì	12.5	12ì

13.0	13.0	13.0

13ì	13.5	13ì

14.0	14.0	14.0

Notes:
1. You can de®ne form lengths in one-sixth of an inch increments at the Display Touch
Screen. For reference, see 8å/< and 8æ/< above.
The stacker control panel does not allow form lengths in one-sixth of an inch. The
smallest increment allowed on the stacker control panel is one-third of an inch.
2. Setting equals forms length as measured from fold perforation to fold perforation.
3. Form lengths as prefolded greater than 14.0 inches are permissible if the stacker is
disabled and a postprocessing device is installed and enabled.

291

IBM 3000 manual Appendix A. Valid Form Lengths in Inches