Adjusting the Stacker Table Height

When you change forms on the printer, it may be necessary to change the height of the stacker table. For example, going from very narrow to very wide forms could make it necessary to shorten the height of the output stack and thus reduce the weight of the stack you have to unload.

Raising the height of the stacker table reduces the height (and weight) of the output stack that causes the STACKER FULL message to appear on the Display Touch Screen. The shorter height of the output stack means you have to unload the stacker more often, but a short output stack weighs less than a taller stack.

Conversely, lowering the stacker table increases the height of the output stack and the STACKER FULL message appears on the Display Touch Screen less often.

COUNTER

COUNTER

5

 

10

250

 

15

 

20

300

 

25

 

HC6OG077

Figure 24. Stacker Height Control

To adjust the output stack height, do the following:

1.Remove any output on the stacker table.

2.Open the front left cover.

3.Loosen the knob by turning it counterclockwise.

4.Raise or lower the knob to the desired stack height.

5.Tighten the knob by turning it clockwise.

6.Close the front left cover.

Chapter 6. Operator Responsibilities 117

Page 149
Image 149
IBM 3000 manual Adjusting the Stacker Table Height, Stacker Height Control