
| Threading Without Printing |
| 1. SELECT the No option within the Print While Threading? ®eld. |
| 2. SELECT the Start pushbutton. |
| 3. SELECT the Forms are Connected pushbutton. |
| 4. SELECT the Feed to Align pushbutton on the Thread/Align Forms window. |
a. This prints a solid alignment mark after the leading edge on a page in | |
Printer 1, which is designated as an alignment page. | |
A | |
shows whether Side 1 or Side 2 of the form is being printed on Printer 1. | |
This prints a dashed alignment mark after the leading edge of the page. | |
| b. This feeds a ®xed length of forms through both Printer 1 and Printer 2. |
| The ®xed length is based on the ªLength of Forms Between Transfer Pointsº |
| con®guration item length that is shown on the Con®gure Printer window |
| under the Con®gure |
| Form Name page length that is closest to the ªLength of Forms Between |
| Transfer Pointsº length without exceeding it. |
| 5. Visually verify that the dashed alignment mark that is printed on Printer 1 is |
| aligned to the appropriate alignment mark on the input station on Printer 2. |
| a. If the alignment mark is aligned at Printer 2, check to see if there is a |
| sufficient buffer loop of forms between Printer 1 and the Buffer/Flipper |
| Unit. If the buffer loop needs to be increased, change the ªLength of Forms |
| Between Transfer Pointsº printer con®guration item. See the table item on |
| page 223 for more information. |
| b. If the Printer 1 alignment mark is short of the alignment mark in Printer 2, |
| SELECT the Printer 2 Feed Page pushbutton on Printer 2 as many times as |
| necessary until the Printer 1 alignment mark is aligned at Printer 2. |
| c. If the Printer 1 alignment mark is past the alignment mark in printer 2, ®rst |
| add some more buffer loop between Printer 1 and the Buffer/Flipper Unit |
| by SELECTING the Printer 1 Feed Page pushbutton several times. Then |
| SELECT the Cancel pushbutton on the window. |