
www.ti.com
|
|
|
| SRIO Registers |
| Table 115. Port Control CSR n (SPn_CTL) Field Descriptions (continued) | |||
Bit | Field | Value | Description |
|
21 | INPUT_PORT_E |
| Input port receive enable |
|
| NABLE |
|
|
|
|
| 0b | Port is stopped and only enabled to route or respond I/O logical MAINTENANCE packets, | |
|
|
| depending upon the functionality of the processing element. Other packets generate | |
|
|
| ||
|
|
| device. Control symbols are not affected and are received and handled normally. | |
|
| 1b | Port is enabled to respond to any packet |
|
20 | ERROR_CHECK |
| This bit disables all RapidIO transmission error checking. Device behavior when error checking and | |
| _DISABLE |
| recovery is disabled and an error condition occurs is undefined. | |
|
| 0b | Error checking and recovery is enabled |
|
|
|
| Error checking and recovery is disabled | 1b |
19 |
|
| ||
Reserved |
| Reserved |
| |
3 | STOP_PORT_FL |
| When set, this bit causes the port to set the Port Error bit in the Port n Error and Status CSR and | |
| D_ENC_ENABLE |
| stop attempting to send packets to the connected device when the Output | |
|
|
| set. Packets are discarded if the Drop Packet Enable bit is set. When cleared, the port continues to | |
|
|
| attempt to transmit packets to the connected device if the Output | |
2 | DROP_PACKET_ |
| When set, this bit allows the output port to drop packets that are acknowledged with a | |
| ENABLE |
| ||
|
|
| and the current error rate falls below the failed threshold, the output no longer drops packets | |
|
|
| (switch devices only). When cleared, the output port continues to try to transmit packets that have | |
|
|
| been rejected due to transmission errors |
|
1 | PORT_LOCKOU |
| Port Lockout: When cleared, this port is enabled to issue any packets. When set, this port is | |
| T |
| stopped and is not enabled to issue or receive any packets; the input port can still follow the | |
|
|
| training procedure and can still send and respond to | |
|
|
| ||
|
|
| device. |
|
0 | PORT_TYPE |
| Port type. This indicates the port type, parallel or serial (read only). | |
|
| 0b | Parallel port |
|
|
| 1b | Serial port |
|
SPRU976 | Serial RapidIO (SRIO) | 189 |